Dual motor driver shield

The ITEAD Dual Stepper Motor Driver Shield enables your Arduino or compatible microcontroller to drive two stepper motors. This Arduino shield is specifically designed to drive two independent 4 pin bipolar stepper www.doorway.ru: ITEAD Studio.  · Dual step motor driver shield can drive 2 step motors (4 wires 2 direction) at the same time. On dual step motor driver shield, there is a setting group for micro-step resolution. They can be set by the hardware jumper, and set by pins of Arduino or other controller.

The VNH3SP30 Dual Monster Motor Driver Shield is a 2-channel DC motor driver shield that can drive 2 motors at up to 9A sustained. Cytron 10A Dual Channel DC Motor Driver Shield for Arduino Uno. The Dual Motor TinyShield allows you to drive two independently controlled DC brushed motors from your TinyDuino. Create your own tiny robots or drones! Using two of the super miniature but very powerful 2mm x 2mm TI DRV Motor Driver (H-Bridge) IC, this shield will allow for up to A per channel and operate motors between to 11V.

INTRODUCTION: This is Cytron newly revised dual channel 2A motor shield. It uses LP chip which allow control of two 5 - 26V DC brush motors with maximum. This Arduino compatible LP Motor Driver Shield DC uses a dedicated high-power LP motor driver chip. Directly drive DC motors and two-phase. Arduino Motor Shield LD. Control DC, Stepper Servo with LD Motor Driver Shield. ₫. Mã sản phẩm.